|
Hold on to
your cranium: check out the world's most powerful automated
system for the guitar player who needs to hot swap amps, heads,
speaker cabs or any other hi-power signals.
The HeadTrip is a powerful audio routing
system with an all analog relay-only signal path for absolute
signal purity. When the effect loops are bypassed, there is a
direct hard wired connection between the instrument and the
amplifier to insure full fidelity and purity. All signals and
grounds are completely isolated between amp heads, between
instruments and between the audio and control circuitry to
eliminate any possibility of ground loop problems (groovy!).
Even the footswitch simulator relays are isolated.
With the HeadTrip you can:
-
Select either of two instruments
-
Insert up to two mono FX loops in series
into the audio path
-
Route any 1 of up to 3 heads to 1 or 2
speaker cabinets
-
Route any 2 of up to 3 heads to two
speaker cabinets connecting any one head to one speaker and
any other head to the other speaker.
-
Fully protect the amp heads that are not
currently selected by muting the inputs and loading the
outputs
-
Monitor the internal loads and mute inputs
as required as added protection in the event of cable
miswiring
-
Switch up to 8 footswitch inputs of amp
heads to replace mechanical footswitches for channel selection
or reverb control
-
Do all switching under MIDI control using
either Program Change commands or Control Change commands
(Instant Access switches)
-
Do all switching using a dual momentary
switch on the footswitch input with various combinations
available using a Mode Selector Switch.
-
The HeadTrip is capable of handling any of
the following loads on its head to speaker audio path:
-
In the event of power loss the HeadTrip
automatically reverts to instrument 1, both effects bypassed,
amp head A, speaker 1 and 2 and full load and mute protection
on heads B and C
 |
